DIY Kite Messenger Parachute Drop

A kite messenger is a clever little device that slides up a kite string, releases a light payload, then slides back down to the bottom of the string for more fun. I made one with some cheap materials and finally found some windy days to test it out. Some kite messenger designs use sails to pull up the kite, but I’m starting out with a simpler design that uses toy parachutes to catch the wind. It can be made in just a few minutes using drinking straws, wire, tape, and a toy parachute.

IMG_9639
Here’s how it works: The front loop of the wire hits a simple cardboard bumper attached high up on the line. As the wire stops, the rest of the unit continues forward, opening the middle section where the parachute is held. Once the parachute releases, the messenger slides right back down towards the spool of string, ready to be reloaded for more fun.IMG_1338
 IMG_9644IMG_9648
IMG_9652It’s fun to see the kid’s excitement build as they watch the messenger climb up the string, eagerly awaiting the parachute’s release so they can chase it down.

Here is a tutorial on how to build your own kite messenger. I used replacement Tervis straws that I purchased at Bed, Bath, and Beyond, because they’re much sturdier than your average soda straw. To hold it all together I used packing tape as well as a bit of super glue for good measure. The climb to the top of the kite line seemed to take a little long, so my next modification will be to use a much lighter gauge wire to reduce the overall weight.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s